Touil soufiane

MrPLC Member
  • Content count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Touil soufiane

  • Rank
    Hi, I am New!

Profile Information

  • Country Morocco
  1. Loading a CSV file into an Omron PLC

    Hi,  Thank you for your response . the files i want to send contain coordinates where the machine head should go down , and this depends on the type of product present , this product is detected by a proximity sensor and the information is automatically sent to the pc via RS232 . Actually there is an application that take the decision of what is the file that should be sent without human intervention , only an execution in the first of a cicle is required , unfortunately i don't have the source code . Thank you .
  2. Loading a CSV file into an Omron PLC

    Hi everyone,  I want to send a CSV file via host link protocol (OMRON PLC CJ1M).  Is that possible ? if So , how can i do it ?  i don't a have a single CSV file , i need to load a csv file into the PLC everytime we change the product incoming in the automatic insertion machine , how can i do that automatically without human intervention  Thank you Regards
  3. Hi, i need to charge an omron PLC with a csv file according to his need , and for that , i have to wait the information from the PLC in order to give it the CSV file in need. How can i do that knowing that i need to do it automatically for 5 PLCs with a single PC and i must use serial connection. Thank YOU .
  4. Hi PLC community,  i'm working on a project with Omron PLC CJ1M CPU 12, my topic is to control 5 PLCs (CJ1M CPU 12) with one PC . the current state is :- each PLC is controled with one PC , and each one of them order an automatic insertion machine.                                    - each machine contains a proximity sensor ( BALOGH) that detecte the reference of the PCB( metalic card) there is a sort of communication between the PC , the PLC and the proximity sensor : from what i understood already , the proximity sensor detecte the reference of the metalic card , which is connected with the omron PLC (CJ1M CPU 12) , and finally there is a serial connection between the PC and the PLC that circulate the information given by the proximity sensor , the PC contain an application ( i don't have the source code) that compare the information given by the plc via serial connection and charge the suitable coordinates in the PLC in order to place the electronic component in correct place. this instructions done by each PC that control his PLC. any solution to generalize the work done by 5 PCs , with one and only PC ??  Hope it's all clair and have a response as soon as possible . Regards.