Omronguy

Hi, Try with the link below, hope it will help you. http://forums.mrplc.com/index.php?/topic/30096-sending-sms-with-plc-cp1l/

Thank You all for help, I manage somehow to assume(after a lot tries) the IP adress and  it was 192.168.0.50 so I can go online on PLC now. Thank You very much once more!!

Dear Gentlemen, I have used CJ1M - CPU 12 - ETN PLC. I m very new at Omron, so my question is: Can I connect from Cx-programer to PLC via integrated ethernet port or the peripheral port is only way(I do not have the communication cable)??  I know that integrated ethernet  acting like ETN 21 module, and that my last oct. of IP adress need to be set in node (transferd to hexadecimal).  Do I maybe need to use FINS and Cx integrator and how to setup my computer (cx programer) there???  Thank You very much in advance!!

I have ERH red blinking all the time, so my Ip address is not correct. Is there any way to do master reset on Omron without connection on PLC??

I allready try, I put my PC Ip adress to 192.168.250.1. and subnet mask to 255.255.255.0 node on PLC is set on 2 so PLC IP shold be 192.168.250.2 and try to connect, but nothing happens. I tried to switch on Ethernet, Ethernet/IP , but could not connect...    

Dear Sir, Thank You once more, I will tried it tomorow. Do i need to put DIP switch 5 to on position??

Dear Sir, Thank You very much for answer. I'll definitely buy the cable, but is there any chance to communicate via ethernet port??