Sprudle
MrPLC Member-
Content count
9 -
Joined
-
Last visited
Posts posted by Sprudle
-
-
1 minute ago, strantor_ said:I'm curious why Norwegians use "PLS" instead of "PLC." I have worked with a lot of machines from Norway and the PLC is always labeled "PLS." Here in the USA, "PLS" means Programmable Limit Switch. What does PLS stand for in Norwegian? Just curious, thanks.
PLS: Programmerbar logisk styring
=
PLC: Programmable Logic Controller
The same
Sry for language mix!
-
Hello
Does someone have a good way to control pressure using PID in cx-programmer?
I got two pumps and one PT(4-20mA)
Half the year only one pump need`s to run (about 3bar)
but in the season (i work in a fabric) two pumps need to be running (about 4bar needed) except in the night.
I`m going to use HMI for adjusting the setpoint so there is no need for any clock/date for this to change itself.
The question is how to get one of the pumps to shut down when the need for pressure is not so high. And get the pumps to change "main" pump sometimes so one pump is not running all the time.Hope this was understandable
-
-
Thank you so much for your help!
A new question:
Anyone got a nice idea for PID control when controlling two pumps with only one pressure transmitter? (4-20mA) -
-
the "IO Table and Unit Setup" option is missing in CX-Programmer
The "I/O Table and Unit Setup option" is missing in CX-programmer (left side under the PLS) and is greyed out under PLC-->Edit--> tab.
Is this the only way to fix it?
https://www.myomron.com/index.php?action=kb&article=1384 -
Thank you for answering!
I will try this first in the morning and let you know
-
Hi
I am a beginner within PLC, I have attended high school and will attend an oral and practical test in January. To become a "licensed"
automatician. Total 4.5 years of school and practice. (NORWAY)I have programmed a little omron before, but not with HMI
I'm having trouble getting plc to communicate with HMI.
I get CX-Designer to communicate with both PLC and HMI.Hardware:
CP1L-EL20DT1-D
NS5-SQ11B-V2
W4S1-03B Omron 3-port basic ethernet switch
3x Ethernet Cat.6 patch cableThanks for reply
Open project ERROR
in NJ Series / Sysmac Studio
Posted
Hi
I want to look into a program i recieved, but i get this error when trying to open it.
Im running the 30day trial atm, but i got the same error when I ran the 1.45 version earlier.
Never used sysmac before, so if anyone has a tip, it would be nice