Face Book

MrPLC Member
  • Content count

    47
  • Joined

  • Last visited

Community Reputation

1 Neutral

About Face Book

  • Rank
    Sparky

Profile Information

  • Gender
  • Location The World
  • Country China

Recent Profile Visitors

2036 profile views
  1. Unable to connect to PLC via VPN.

    Hi Sir, Iam confuse about the procedures for Connecting remotely into simatic cpu through teamviewer VPN in a certain document in internet " JesperMP "  describes to enable IP routing in remote PC . In other document describes to enable IP routing  in office PC. In other document,enable IP routing in both PC. I do not know what is the correct. Can you explain this point? Thank you in advance. How to setup Teamviewer VPN.pdf
  2. Beckhoff CP7702-1422-0040

     Hi, The designer not gave us this information. Do any member have this manual? https://www.classicautomation.com/Part/cp7702-1420-0040 Thank you in advance.
  3. Beckhoff CP7702-1422-0040

    Hi Sir, Thanks for your reply. I saw and read it but did not find the input signal for each button when press it  and the output signal for each button lamp to energizer it. Please help me because Beckhoff support not helped.  
  4. Beckhoff CP7702-1422-0040

    Hi, In our  filling machine:  the designer installed Beckhoff CP7702-1422-0040 This CP contains a digital  I/O modules  inside it at the back side . Do any member have any docunent or manual that explains how to program the Buttons and the lamps in the front side? Waiting your replies. Thank you in advance.  
  5. B&R Modules in Simatic Manager Program

    Thank you for your help
  6. B&R Modules in Simatic Manager Program

    Hi Please Check the addresses in the attached photo. Am I right?
  7. B&R Modules in Simatic Manager Program

    Hi If we have  X67DM1321.L08   I/O as in attached photo in HW Configuration: I  Address:86.......91 Q Address:86....89 What are the addresses for these channels in this case?
  8. B&R Modules in Simatic Manager Program

      I need to know how to address I/O for these modules in general?   "these modules contain large byte of I/O addresses"
  9. B&R Modules in Simatic Manager Program

    Hi  What are the physical I/O addresses that used in these modules? "these modules contain large byte of I/O addresses"
  10. B&R Modules in Simatic Manager Program

    Can you draw a  diagram explain the connection between the modules?
  11. B&R Modules in Simatic Manager Program

    Yes But Iam not understand the connection between them Can you draw a  diagram explain the connection between the modules?
  12. B&R Modules in Simatic Manager Program

    Hi 1-How the modules connected in the table in the attached photo? 2-What is the difference between them? 3-What is the relation between  X67BC6321.L08 and the modules in the table?
  13. B&R Modules in Simatic Manager Program

    NO ----- I don't find  all of these I/O address in the PLC modules ------ What is the relation between  X67BC6321.L08 and the modules in the table? ------ Module: X67DM1321.L08 and reserve 10 byte for digital 16 I/O Module How?    
  14. B&R Modules in Simatic Manager Program

    Hi X67BC6321.L08 X67DM1321.L08 And other modules I don't find  all of these I/O in the PLC modules
  15. B&R Modules in Simatic Manager Program

    HI The program is already run without any problem as the designer do. I need to know the concept of this.