-
Content count
15 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout Nouhaila Lazaar
-
Rank
Sparky
-
Hey, I can't connect to the plc via ethernet. can you tell me the steps you did to do it?
-
-
I didn't turn the power off but I tried after to make the connection in vain. the video thaT I posted (min: 1,25) I don't know if I have to remove the USB and connect ethernet crossover cable. in both cases it shows me a problem ( see photo attached)
-
yes, I set it when I want to connect to the plc
-
I tried what you've told me and it didn't work . I followed the steps in the video that I posted last time by connecting the USB cable to the PLC and entering the settings in CX-P then I removed the USB and connected ethernet crossover cable. But I wasn't successful to be connected to the plc. what did I do wrong?
-
the node number now is set to 63(hex)
-
ah okey, thank you. So now if I could connect Cx-P to the plc i'll be able to use Cx-supervisor too. the adress 10.46.10.1 is used by another PLC I can change the node can't I ?
-
Thank you so much for your help, i'll try this and let you know if it works or not. I just can't understand why the node number is not 0. If I do the steps that you've told me i'll be able to connect to plc directly , I don't need a switch, do i ?
-
Thank you for your response, it's the first time that I work on this that's why. my node number is 0 (X10e0) and 0 ( X 10e1) CJ1W-ETN21 : unit 3 that's why the last octet of my IP adress is 0 :/ I didn't know that i'm not allowed to do this . the IP adress of my PC is 10.46.10.100. by the way I asked for gmail because i'm not allowed to put the CX-Programmer file here, I wanted to send it to in private
-
okey, here is a picture of my ethernet settings. I followed the same steps in the video. Can I contact you on Gmail? Am I doing something wrong ?
-
okey, here is a picture of my ethernet settings. I followed the same steps in the video. Can I contact you on Gmail?
-
hey, How can I connect to scada on laptop with PLC directly. And have you been able to connect PLC and laptoo computer to ethernet switch?
-
Hey again , Can you please put the pictures here ?
-
OK thank you, I have a problem, I can't connect my pc to the plc ( CJ1M CPU 22 ) via ethernet (ETN 21) , can you help me? I will be grateful
-
Hey, I can't see the pictures, I have the same problem