MrPLC Member
  • Content count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Milosh

  • Rank

Profile Information

  • Country Yugoslavia
  1. What is the difference between these two bacplanes? Can we mount cpu to io expansion backplane?
  2. Cpu position in rack ?

    Hi all Is there any problem if CPU is put like this (from right to left) slot 1 - PA209R slot 2 - ID231 slot 3 - ID231 slot 4 - OD231 slot 5 - OD 231 slot 6 - CS1H-CPU64H   On CPU is program logic (with all configurations). CPU have different rack informations. I need to put it on rack (above) and upload program code to PC.    
  3. Is there any problem if cx supervisor installed on the same machine with cx programmer and cx desiner? Some driver problems, etc. What is your expressions?   Best regards, Miloš
  4. Upload from CS1H PLC?

    I should to connect with direct (auto) mode?
  5. Upload project from NS5-SQ10

    Is that cable same as connecting to Omron PLC CS series? Should I need to do something on the PT before transfering? Or on the Cx-Designer?
  6. Upload from CS1H PLC?

    Hi all. I want to know what is the procedure to upload project from PLC model CS1H? Does the PLC goes to stop mode if I start uploading? Best regards, Miloš  
  7. Upload project from NS5-SQ10

    Hi all, Can someone explain how to upload project from NS5 HMI? 1. Which cable to use and which software? I tried with crossover rs232 cable to port A, but can't upload project? 2. Is it better to use USB cable? 3. Do I need to change something on DIP switches on HMI device?   Best regards, Miloš
  8. Change title bar of pop-up screen

    Thanks for reply. Yes, that is one solution, but in that case I don't have posibility to move pop-up screen around the base screen.
  9. Change title bar of pop-up screen

    Close button on title bar is all grayed, and like that, is not have good visibility. I hope that I can change it to standard red button with white X.
  10. Hi all,   Is there any way to change title bar settings for pop-up screen like font, close screen icon etc?   Thanks in advance, Miloš
  11. Detect wire break on omron absolute encoder

    Thanks all for reply. Sergei: Yes, I would like to have possibility to detect broken wire as soon as possible. gclshortt: Sometimes the encoder will not move for full turn. Operater can start machine, and very fast can stop. In that case encoder would not make full turn. Also sorry for my previuos wrong answer, about full turn. I thinking about this solution: when machine started, encoder turning, for every wire (signal) I need to check if state changes during defined time interval. If state changes everything is ok, but if not I shoult to stop the machine and set error flag. But I need 10 flags for errors, and 10 timers to detect that. I'm just looking for some easiest solution.
  12. Detect wire break on omron absolute encoder

    Yes, encoder makes full turnduring operation.  
  13. Detect wire break on omron absolute encoder

    Thanks for reply.  I have 10bit omron encoder with gray code. Every of this bits goes to one digital input on digital input module.   
  14. Detect wire break on omron absolute encoder

    Thanks, but I can't use this instruction with plc  I have. It is cs1d and gry instruction is not supported.  
  15. Hi all. How to detect on 10bit gray code absolute enncoder that one wire is broken? It is wired to plc digital input card. Is the solution to use timer and check every wire if signal not change during defined time interval then set error...or something similar?