Zerosignalz

MrPLC Member
 View profile  See their activity

  • Content count

    3

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Zerosignalz

  • Rank
    Hi, I am New!

Profile Information

  • Country Canada

  1. NT20S screen stays at "Connecting to Host"

    Zerosignalz replied to Zerosignalz's topic in Other Omron Software

    ok got parity set and it connected to the PLC and the first screen comes up, but after a second or so it disappeared, I searched and found another thread that dealt with this. I made sure at the DM1000 I put a 1 , but the screen still disappeared,  So I used the mov #1 to d1000 and it is working!!! Just wanted to give a final answer to what fixed it for anyone searching later.   Thanks So Much Michael
  2. Zerosignalz liked a post in a topic: NT20S screen stays at "Connecting to Host"

  3. NT20S screen stays at "Connecting to Host"

    Zerosignalz replied to Zerosignalz's topic in Other Omron Software

    I have both units set to Host link , 9600 baud rate. I don't know where or what parity and stop bits are. I have the dip switch#5 Port  set to auto. I believe the cable is correct I used the drawing from one of the tutorials, but will double check to be sure.   Thanks
  4. Hello, I have an old NT20S-ST121B-EV3 and a CJ1M-CPU13 I would like to use them  together. But all the NT20S does is say "connecting to host." I have been able to connect to the NT20S and load the application. I set the PT control to DM1000 and the PT notify to DM1100. I have made a C200H-CN510 cable to connect between the CJ1M and NT20S.   Any help would be appreciated. Thanks