Storm

MrPLC Member
  • Content count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Storm

  • Rank
    Hi, I am New!

Profile Information

  • Country Indonesia
  1. Actuali this machine has been commissioning last year, because of other problem to support the building problem we dont run it until last February, It was running properly, and now has a problem.
  2. Its has measured each phase come up value 0,01. (On motor) and for wire was 0,07. We tried to run the motor by using other wire and plug into power point  3 phases and motor was run ok each phase show 7,8 Amperes. For Siemens Sirius temperatur monitor relay, we changed it already. Once it was connected to existing wire the tripped light also on. I just wonder is it posible the output power of inverter below 380 ? Each phase shows 277 volts, 284 volts and 268 volts. I have set the value in inverter according to motor name plate and started it by pressing bottom at inverter, the motor was turning. But we cannot start it by using PC from control room.😢
  3. My Sew Eurodrive MC07B0150- 503-4-00 have problem where the Siemens sirius 3RN1010-1-CW00 Temperature monitor relay keep Tripped, i have checks:  the motor has no problem, input power to inverter 380 volts 3 phases, Hz 50, RPM 1460, Power 9.2 kwv and A =18. i found the output of inverter less then 380 volts. please give me suggestion what to do. thank you