Til123

MrPLC Member
  • Content count

    10
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Til123

  • Rank
    Sparky

Profile Information

  • Country United Kingdom
  1. Hi Ken, The Kinetix is to replace a stepper motor controller card, pulse expander card, and a encoder counter card. There is rack space. I'm not sure of the required size of integer until I receive the drive. The current system has several rate changes and position  feed back to the PLC   Cheers 
  2. Hi, has anyone ever managed to communicate with a Kinetix 300 servo drive from a Plc 5/15? We have DH+ on the PLC and Ethernet ip on the drive? I have seen the 3rd party network bridge but have no experience on how this works. The hardware looks easy enough it's the comms/messaging I need help with   Cheers
  3. Rsview 32 data display

    Hi, can anybody shed any light on this issue? We are running rsview32 connected to a plc 5/40 it is running a simple calculation in the ladder, when the result is higher than 0 it is fine however if the result shoukd be 0 the display shows ###. Has anybody seen this or know how to cgange it?
  4. Ab plc 5/15 ife

    Thanks that make sense. 
  5. Ab plc 5/15 ife

    Hi, thanks for that. Sorry for dragging this out but they don't seem to be the values I am expecting. This is off a vacuum welding machine. the datasheet for the transducer (mpa) 8.5v at atmosphere 1000mpa, then 7.5v at 100mpa, 6.5v@10mpa, 5.5v@1mpa, 4.5v@0.1mpa, 3.5v@0.01mpa, 2.5v@0.001mpa, any lower iunder scale for the instrument. As it is a vacuum machine they are particularly interested in the lower values. is it am exponential formula? Thanks again sorry
  6. Ab plc 5/15 ife

    Ok thanks, the measured min v is 2.5v, the transducer goes under scale at below 2.2v is what I was trying to explain.   Thanks for the replies, sorry for the confusion 
  7. Ab plc 5/15 ife

    Hi, sorry trying to write these on my phone which isn't going to well! It should be 0.001@2.5, 0.0001 anything lower than 2.5v Thanks 
  8. Hi, can anyone help me with the correct equation please? I have a 0-10 v analog input scaled @ 0-10, however I need the hmi to read 0.001 @ 2.5 v, 0.01 @3.5v5v, 0.1 @ 4.5v, 1.0@5.5v, 10@6.5v, 100@7.5v, 1000@8.5v. This is linear starting from2.5v through to 8.5v
  9. Ab plc 5/15 ife

    Thanks Mickey, I have done as you say and it worked thanks. C an you help me with the requirements compute function? I want low scale to read 0.0001 and high scale to be 1000.  Dave   
  10. Hi, can anybody help me with an analogue input on a plc 5/15 via a 1771 IFE card. The input has been used with a 0-10vdc input, however there is some nasty compute functions to create a logarithmic curve for the Scada. we now need a linear calculation from 2.2v-8.5v. 2.2v = 0.0005mpa through to 8.5v = 1000mpa. I am familiar with the slc but the commands are somewhat different  Cheers