varun_pandey

Ya I posted that in Schneider forum. By mistake I posted this in Omron forum. My Bad.

Hey Guys!!!! I'm trying to use ASCII 8 bites in TWIDO PLC and on MOD BUS TCPIP it connected to WinCC , where I'm trying to read the ASCII in as a STRING char that to in 8bits. The problem I'm facing is that it is getting swapped like if I'm writing VA in PLC then on SCADA it is showing AV. In WinCC there is no setting for word swapping. Therefore Kindly help me for this in plc end

Hey Guys!!!! I'm trying to use ASCII 8 bites in TWIDO PLC and on MOD BUS TCPIP it connected to WinCC , where I'm trying to read the ASCII in as a STRING char that to in 8bits. The problem I'm facing is that it is getting swapped like if I'm writing VA in PLC then on SCADA it is showing AV. In WinCC there is no setting for word swapping. Therefore Kindly help me for this in plc end

See the Date Instruction Told By You was Perfectly Good.....I was trying to check the instruction via Simulation Mode as I didnt have the PLC and The PLC is on Site. As we can check the code in Siemens therefore i thought that we could do the same there also. On site I used the Date Instruction and the clock was synchronized perfectly!!!!

Problem Solved!!!!!

I'm using CP1E-N30DR-D and on going online i can see the PLC CLoCK and also in A351-354 i can read the time ....But..... i want to write the time as in my case the time should be sync with my NTP server. For this i want to write the time in the PLC but via using DATE (735) instructions i cant make it work.As the time i write in the DATE instruction remains the same and the clock time doesn't increases with the change in TIME. And as soon as I unforced the bit the Time of PLC again changes to the original and the clock also starts moving again. So kindly help me ...or enlighten me with same. Or provide me some sample code though i have gone through the sample code given in the help section for DATE Instruction but i cant make that work!!!!  

@ BITS N BYTES Since I'm new to OMRON I wanted your help!!! I'm trying to read and write time for CP1E PLC but only i could get to do is read the time. Though I used DATE instruction but that too in vain!!! So if any one or u have any instruction or Sample that would be good.I read 1 manual and found to use r;CLOCK WRITE FINS (0702 HEX) but I could not get this instruction Can U help me? PS other member's are also kindly welcomed to give me advice!!!