Kali Rajan

MrPLC Member
  • Content count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Kali Rajan

  • Rank
    Hi, I am New!

Profile Information

  • Country India
  1. yes I have an yellow? mark in my Power supply 1769-PB4 it shows it is unrecognized Device... My RSlogix5000 version 17.00.00 (CPR 9 SR 1)
  2. I have one doubt pls tell some tips or guidens,Iam using this I/O module, but in the RSlogix 5000 my controller is Compactlogix 1769-L32E and i selected the 1769-IQ6XOW4 Series B I/O module. In this I/O module properties there is only revision 2&3. There is no revision 1. In this problem there is any errors or faults are occurs or not...?I connected this i/o module with rev.2.1 configuration and i connected a push button in the Input pins and I programmed for this Input and i download it, After to change the PROG mode to REM RUN mode and if i pressing the push button in my I/O module the input pin 1 turns Orange light. if i released the push button it turns off. But the controller has faulted.(i.e; Fault occurs- Controller fault) Fault type-03 and Code-23 cause:At least one required connection was not established before going to Run mode.Recovery method:Wait for the controller I/O light to turn green before changing to Run mode.But there is no green light indication in my I/O module 1769-IQ6XOW4 Series B Revision 1.1. Is there any IO Module Revision problem or not...How to rectify this fault.... please tell some suggestion...Reply as soon as Possible...