Hello guys!
I'm new to this forum and as well new to Mitsubishi PLCs. I just got a Simple motion set of Mitsubishi FX5U-32MR PLC, FX5-40SSC-S, MR-J4W3-222B and GX Works3 development software.
I'm able to start motor with "Simple motion Module setting" development program, with test mode - Jog mode. When I try to make ladder program using JOG/Inching operation function block, there come problems. I connected all the inputs and outputs as described in User's manual (Startup). When compiling i get an error (11 of them): Error M+FX5SSC_JOG_00A Program Conversion Label which does not exist has been set. 0x11031F0A. The error is inside the JOG function block. As it seems, the contacts inside FB should be labeled, but they arent.
Is there any demo programs for using these function blocks?
Regards,
MM