WebbyNY

MrPLC Member
  • Content count

    9
  • Joined

  • Last visited

Community Reputation

0 Neutral

About WebbyNY

  • Rank
    Newbie

Profile Information

  • Gender Male
  • Country United States
  1. GX IEC Developer

    Thanks! Mitsubishi recommended using GXWorks2 and selecting IEC under tools.  I'd prefer to use IEC Developer, because all the backups we have use this. I've looked in the IEC manual and I cannot find instructions that show you step-by-step how to backup the CPU program. Do you know of any? Thanks!
  2. GX IEC Developer

    Thanks! Mitsubishi recommended using GXWorks2 and selecting IEC under tools.  I'd prefer to use IEC Developer, because all the backups we have use this. I've looked in the IEC manual and I cannot find instructions that show you step-by-step how to backup the CPU program. Do you know of any? Thanks!
  3. GX IEC Developer

    Thanks! The vendor is Swiss and getting information is tough.  
  4. GX IEC Developer

    Hello, I'm trying to figure out how to "upload from PLC' a backup copy of the program from the Q12HCPU. Is anyone familiar with how to do this?   Thank You!
  5. Mitsubishi QJ71E71-100 C013 error

    Gambit: The cleaning command is accomplished once the cassette has moved to the cleaning position and the optical sensor is satisfied. Then the cleaning operation is run from the program, which has been loaded to the PLC and is based on time frames. When we try to duplicate the problem everything operates as it should and no defects are noted anywhere other than the C013 error on the Ethernet module. Why unplug the Ethernet cable? We'd loose communication. Is that what you think would be worth verifying? Thanks!
  6. Mitsubishi QJ71E71-100 C013 error

    Luke S: Thanks! Gambit: The machine will randomly move to the cleaning position with no item in there to clean. Once this happens we have to manually move everything back to the starting position and sometimes we have to cycle power then reinitiate and home the machine. No errors or alarms at the display. Only the C013 error when I checked the PLC.
  7. Mitsubishi QJ71E71-100 C013 error

    Gambit, can this cause the equipment to perform phantom operations? Thanks!   Luke S, What should I do in the Ethernet tab? Thanks!
  8. Is anyone familiar with C013 errors on Mitsubishi QJ71E71-100 Ethernet module? C013 The port number used in a connection already opened is set in UDP/IP open processing. Review and correct the port number of the Ethernet module. Thanks!
  9. GT1655-VTBD GOT1000

    Good Afternoon, Our GOT1000 HMI was wired incorrectly when the vendor installed them. +24V was on ground and ground to +24V post. Everything was working fine until our Ionization system was being tested/calibrated with a 1000V charge plate placed in the tool. Then the GOT1000 HMI display went blank and no indication lights were lite on the front. I swapped the wires and the HMI works fine now. It's understandable that it faulted when the ION systems were being checked due to the polarity problem caused by the wrong wiring. The question I have for anyone who might know is, why was the GOT1000 HMI working at all with the wiring wrong like is was? Thanks, Webby