ConfusedStudent2016

MrPLC Member
  • Content count

    12
  • Joined

  • Last visited

Community Reputation

0 Neutral

About ConfusedStudent2016

  • Rank
    Sparky
  1. Ge Fanuc 90-30 setup

    Yes the PC and PLC are on the same network. I have pinged the PLC to begin with however, it doesnt let me work online I belive its beacuse I do not have the name server ip.        
  2. Hello, I am a student that has been taught ladder logic for three years( on many different plc's ) but, I would like to learn an alternative method is there any way to convert ladder into Function Block or some other type of programming in RS logic 5000 or any other controller? If not can some one explain the basics of Function Block programming.
  3. Ge Fanuc 90-30 setup

    Hello,  I am a student currently working on a project involving Ge Fanuc. We have not learned anything about this controller however I have a strong backround in many other PLC's(Allen Bradley,Omron,Siemens). I would like some help configuring this device. I have read the manual for the fanuc controller and I have added all the modules and power supply; however, I am not able to download I have checked the ethernet setting on the controller module and I have had no luck. I have some knowledge of networking so I have choosen thr correct: IP,Subnet and Default Gateway. If you have any information that may be helpful please reply.   (I am using cpu 364 if thats helpful).  
  4. Sequencer Input

    Hey I have created the sequencer input but the position does not change by itself however I know that its working as it does energize the output bit.
  5. I was able to figure it out thanks
  6. Help With SQO in RS 5000

    Thanks a lot!
  7. Sequencer Input

    I have a program using the SQO instruction. However, I am looking to control my program with a sequencer input. I have never used the sequencer input before and I have 16 sensors to move cylinders using the sqo.
  8. Thanks for the reply, I am still having a issue understanding the parameters of the SQO. also is there a way to trigger my sqo witout a timer? 
  9. Help With SQO in RS 5000

    Hey, I'm using rs 5000 with a sequncer instuction, I have used a sqo in 500 before but I am looking for some guidence in 5000. What should I use as my fields( the parts of the sqo) and where is my sequencing table like the #B3 table. The process is as described below: Move 8 cylinders in correct sequence ( I have made my table in both binary and decimal) Do not use the timer instruction in the program Thanks  
  10. Hello, I am new to this forum and I am looking for some help. I have to create a block mover system using the controllogix , I know that I must use a SQO as I have done this process without a Flex I/O on a SLC 500 before. Currently I am getting a error while dealing with the array can anyone show me an example of a SQO in 5000?   Thanks