aakash

Hi We were using Fx3g -60mplc with Fx 3u 485 adp -Mb , Fx 3g -cnv -adp module with  A510Teco drive and delta Hmi to monitor n control motor rpm.the drive  got faulty and we are trying to use schneider drive Atv320u75n4b .But cannot monitor the drive from delta plc .I know there may be some communication setting to be made  .Any idea what changes to be made.   Thanks

hi I am new to siemens ,want the help with plc to step 7 communiaction , I have IM151 -8 pn/dp cpu can you tell me how to communicate with step 7.   thanks   Aakash

hi actually this was for practice only to learn then i can use when i need .i like to know the difference between them thanks

Hi thanks i tried that with already used c251 2phase 2 count. Not sure the use of 1 phase 1 count ,2 count they have the same connection to plc i have to connect both A and B phase.

hi ,thanks for the help i was just programming it i had problem.At wiring do the input X0 ,X1 of plc can be either source or  sink type.The encoder will give pulses , do i have to make any changes or i can just it either way  

hi i have seen there was no mention i am looking at wrong manual.you have the link for the same

i want to know where to connect ,what counter can i use.  I want it to program for 0 to 360 ,also can i know the direction of rotation . encoder -TVI50N-09BK5A6TN-00360  

hi actually i have never tried plc to encoder programming , i have the FX3S-30M plc with encoder ,can someone help me programming the encoder to have better understanding .   Thanks   Aakash

i hope  the rx , ry are used to define that .thanks for the help actually i was having system where cc link module connected to base unit with plc  Quo4udeh cpu was connected to cc link at the seperate base unit with cpu q02udeh cpu .I check the cc link parameter ,there the setting were as mention .I wasnot sure why it was used. note cc link    QJ61BT11N regards   aakash

Hi there I know most of you know but i was confused that  cc link used to communicate between two plc or plc and io module are they able to communicate all the Inputs and outputs.what i exactly want to know that cc link can transfer all the inputs and outputs to plc which is mounted at different place   Regards   Aakash

i am  using gx works 2 ,there is hmi connected .yes can be batch command thanks though  .

hi we are using q03udeh cpu ,on other day i was facing some problem i saw that particular latch relay ( l1064)was getting activated  , but could not figured out how is it  activated , Can someone help with that   regards   aakash  

you should go to plc diagnostics and see what kinda alarm it is.What  plc you are using exactly  ?

thanks i wana know to give clk signal is that possible we can input through timers. and use the HSC MODULE maybe the same inbuilt hsc

thank you gambit sir. Couldnt have figure out without your guidance .i dont know why are they not mentioning  that  important info in manual.   Regards Aakash