Theodor

MrPLC Member
  • Content count

    10
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Theodor

  • Rank
    Sparky

Profile Information

  • Gender Male
  • Country Malta

Recent Profile Visitors

796 profile views
  1. FX1N PLC ERROR 8067

    Hi everyone I just receive the PLC, I ran diagnostics and the error that I found was 6706 at step 4041, "Err description: A device has been specified outside of the allowable range for an applied instruction operand" I attached a photo of step 4041. Eddit: thank you I.T.E.T.
  2. FX-EEPROM-16 problem

    You were right ” Innovative Technology, Electronics, Telecommunications”, the program was corrupted, I change the eeprom card with another one with the same program and everything works fine, thanks for helping.
  3. FX1N PLC ERROR 8067

    thanks for the reply! Yes i know that, but i dont have it in front of me, so i can't check these registers or run diagnostics on it yet. I thought that someone might know something about it. i will have it here,in some days, so i will check these rejisters and keep you informed.
  4. FX1N PLC ERROR 8067

    Hi everyone, I have a FX1N conected with an HMI Beijer E100. the application is not working, the plc has no error light but the HMI Says: PLC error 8067 any idea what that error means and how to fix it?
  5. FX-EEPROM-16 problem

    Thanks for the help, i wil do some tests and i will inform you...
  6. FX-EEPROM-16 problem

    Thanks for the help,i try it but it didn't work, the error remains. any other advice?
  7. FX-EEPROM-16 problem

    the program is code protected so i can't read the program.
  8. FX-EEPROM-16 problem

    Hi everyone, I have a problem with an FX-EEPROM that is mounted in an FX3U The eeprom has a switch (protect sw) that is in off position, it seems that someone remove the eeprom card from the plc while the supply was still on. I put back the eeprom to the PLC but a parameter error appears. This eeprom contains the program of the PLC. Anyone knows how to remove this error? Thanks in advance
  9. Conversion MAC E1032 to GT2308 HMI panel

    Thank you Theo V. The information you gave me was very useful.
  10. Conversion MAC E1032 to GT2308 HMI panel

    Hi to everyone, I’m new in the forum, I hadn’t write anything yet but this forum has been very useful to me the past time. I have the same problem with Theo V, I want to convert programs written in E-designer ( for E-Series HMI) to GT Designer3 programs so that I can Download them to GOT2000 series. Gambit,(or anyone elese that might know), I would like to know where can I find this converter?