newbieplc2003

MrPLC Member
  • Content count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

About newbieplc2003

  • Rank
    Hi, I am New!

Profile Information

  • Country United States
  1. Move Function Not Working

    I am very new to PLC's, I work in a power plant and we have an ABB DCS. We have some vendors that use PLC's and they try to make them work with our system. Currently I am working on a project were I am trying to add 8 analog outputs to the PLC. I am working with two 1756-L71 controllers (redundant) and the rev for the program that was written 20.01. Basically I have 8 analog inputs that I want to bring to the spare analog outputs that I have. I want to see these inputs in our DCS. I wrote simple logic that at the end of the rung has a move block moving the source which is the input and taking it to the destination which I made an alias tag for the output channel that would correspond. Problem is I can see the source number moving, but the destination number stays at 0. I can type a number into the destination and it will work. I can see my 4-20 signal I am sending out in the DCS. Everything before the move function is true, I have and open contact, and a closed contact and they both are green. This is happening on all eight of my outputs that I am working on. Please help I have learned a lot from this experience but I cannot figure out what has me stuck this time.