Chris Iwo

Hi ALL, We have a Modicon TSX Premium PLC which has fault and cannot run I am searching for the software to program the Processor and how to talk to it Thank you Chris

Hi JC,   Thank you Appreciate your help The PLC has "BATT Fault" on the power supply module[TSX PSY1610]-what does this mean? Thanks Chris  

Hi All, We have a 4X Rx3i PLCs that use Ethernet Global Data (EGD) to talk to each other. At the moment we a facing EDG communication fault being generated and it trips the entire pumps What the likely causes of EDG faults: We have replaced PLC Ethernet Interface Modules-no fix We have tested the fiber optic cable-the readings show its OK Also,can someone explain what PLC heartbeat is?

Hi ALL, I have a GE PQMII,Redlion Data Station & GE LM90 30 PLC I am trying to map data out of the PQMII to Redlion using Modbus-RS485 and then using Ethernet (TCP/IP) to map data from Redlion to GE LM 9030 PLC. I know Modbus uses hexadecimal and PLC Registers are in Decimal I need a technical procedure on how to configure/program Thank you Chris Ok Tedi Mining Limited

Hi ALL, Am trying to configure a PCM 301 (LM 90 30 Communication Co Processor Module) What software do I use,is it TERMF or PCOP? And where can I buy this software Thanks

Hi ALL, We a have Rockwell Automation FactoryTalk Machine Edition View Station 5.00.00 (CPR 9) that was working fine but just today, operators cannot reset/acknowledge alarms. I have checked network connectivity is okay I need assistance on what could be the possible cause? Thank you Chris

Thanks RussB

Hi ALL, In the Rx3i controller fault table-the following fault keeps coming-up "0.4-LAN System-software fault: resuming" Error Code: 402 Group: 16 Action: 2 Diagnostic Task Num: 6 28001d001400000004011d000000000c0a88066 Does anyone have the definition of this error code and how I can interpret the error? Thanks Chris Ok Tedi PNG

Hi All, I am trying to setup the communication between GEIP PACSystems Rx3i and Schneider Electric CitecSCADA 7.1 Does anyone have the procedure? Thanks Chris

Thanks Russ  

Hi ALL, How do I convert a LM 90 30 (DOS) to a Proficy Machine Edition 8.5 software? Thanks Chris

Hi ALL, Can Schneider Electric CitecSCADA 6.10 talk to AB Micrologix 1100 via a Ethernet Interface Communication Module [1761-NET-ENI ]? And what Citec Driver can I use to set this up? Thanks Chris

Thanks RussB, Will try this

Hi ALL, Am trying to write a PLC code that will register accumulate tonnes from a conveyor weightometer What function blocks inside LM 90 70 can I use to develop this? Need assistance Thanks Chris

Hi, Am trying to setup communication between Allen Bradley Micrologix 1100 controller's ethernet port to Citec SCADA 6.10 What protocols can I use to have Citec communiccate with AB Micrologix 1100 controller? Thanks

Thanks RussB

Is Proficy Machince Edition Version 8.0 compatible with PME 8.5?

Thanks Steve