LittleMac

MrPLC Member
  • Content count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About LittleMac

  • Rank
    Hi, I am New!

Profile Information

  • Country United States
  1. Resetting Genuis IO from Proficy

    I am looking for some help on how to clear faults and reset genuis bus controllers from ME proficy. I have looked through the help files and read a little of the data sheets and I cannot find much. I did read once section that had some logic you add to send the reset cmd to each individual bus addresses, but that seems too complicated.
  2. GE Ethernet Global Data

    I had a similar issue when I was using the same IP address for the Processor as I was the EGD information. I could receive all the information I wanted to, but I couldn't send anything out.
  3. RTC S6PIO GE Series 6 C-Bus interface card

    I just completed a project to remove a S6 processor off of a machine. In our application we have removed all the S6 IO and the only thing we have left is our GE DMC drive controller, which has the S6 C-bus interface on it. We are using the PIO card to interface with the C-bus using the SCAN c-block provide. In your application you need to know if you have you remote racks setup for advanced IO, because you will need to enable that on the scan block. Also, if you have Analog IN/OUT cards, you will have to call two separate c-blocks for those functions as well. You can email me at michael.william.mcdonald@gmail.com if you still need some more help with this. I have a few things that might help. -Michael