Matt

MrPLC Member
  • Content count

    10
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Matt

  • Rank
    Sparky

Profile Information

  • Country United Kingdom
  1. Weirdest thing...

    Have you any comms going on?
  2. Consider upgrading to FX3U and you can make use of the R Registers.
  3. CC-Link problem with PT100 module

    Check the Buffer Memory to see if the issue is with the network or the I/O Refresh.
  4. GX Works2 version 1.73

    Version 1.77F Now available.
  5. Appreciate that, it's 1 month from Launch in UK, (Due to Tsunami). I Don't know the current availability in India.
  6. Use the 485 ADP Module that fits on the Left Hand Side Bus.
  7. Neither the QD75MH or 20SSCH can do true Torque control with the MR-J3-B amplifier. (Only Torque Limit) For Torque control mode with MR-J3-B you need to use Motion CPU, Q172H, Q172D or Q170M. MR-J3-A amplifier supports Torque control. LD77MH4 and 16 will also support Torque control when it's available.
  8. To be clear, A700 VSD with SSCNET III option cards can only be used on the Q Series Motion CPU. (Q172H, Q172D etc). In addition, an Encoder and Encoder feedback card must also be used.
  9. Mitsubishi MR-J2S-A

    Hi, Don't confuse the Servo Motor's encoder resolution with the 'Emulated' encoder output from the Amplifier. The MR-J2S range of Servo motors use an Absolute Serial Encoder with a resolution of 131072 ppr. The Amplifier has an output terminal to allow a pulse train to be fed out that corresponds to the encoder on the servo, however 131072 ppr is not possible. Using Parameter 27 you can configure a ppr of 1 to 65535. 4000 is the default.
  10. A172SHCPUN

    SC09 will get you comms. PCMCIA was SSCNET and SSCNET II adapter to allow faster comms and also diagnostics for High Speed monitoring and Motion Trend / Graph.