bjclem

MrPLC Member
  • Content count

    49
  • Joined

  • Last visited

Community Reputation

0 Neutral

About bjclem

  • Rank
    Sparky

Contact Methods

  • ICQ 0
  1. I am trying to read rpm coming into the card but not having any luck , can anyone help? I get 120 PPR , can someone tell me know to set this up. Processor 1769-L33erm thanks
  2. Modicon I/O

    can you tell me what this module does AS-B531-001 5-28vdc Latching DC
  3. I am converting to a ControlLogix This modules I cannot find any specs on them AS-B531-001 5-28vdc Latching DC - what does this module do ? and how does it latch AS-b559-001 115vac Isolated AS-B558-001 10-48 vdc Input Looking for any specs on these modules Thankyou
  4. I have to interface a PLC5 with a Delta V Dcs looking for the easiest way to get this done . I don't know the dcs side so any help would be great.
  5. yes but with it connect to the panelview plus was getting a unknown device on the usb side I did not try to connect it via ethernet . that is with the hp6980 printer
  6. remote i/o

    I would go Devicenet
  7. I have a Panelview plus that I tried to connect a HP6980 to the USB port and did not work anyone have a list of what printers work with the USB port or do I have to go thur a hub for this to work . The HP6940 I think is on the list it has a usb port and ethernet . thanks for all you help
  8. I am making a cable that goes from a 1747-AIC to a 9 pin serial connector does anyone have the Pin out for this , It is for a Panelview PLus using the serial port to talk to a SLC5/02 , Thanks for your help
  9. IMC-120 User manual

    Micky do you know where I can get the user manual which shows the Block transfer Configuration and programming of it . Thanks Again
  10. Help I am looking for a IMC-120 user manual could anyone tell me where I can find one ? thankyou
  11. HERE IS THE LINK http://support.rockwellautomation.com/firmware.asp
  12. TMR DL405

    TIMER QUESTION , HOW DO YOU PROGRAM A TMR IF YOU USE A k10 THAT WOULD BE A TIMER OF 1 SECOND RIGHT, AND WHERE DO YOU SEE THE ACC VALUE.
  13. CLX TO PLC5

    thanks guys I did use the user manual to fiqure it out . Thankyou are all your replys .
  14. I AM TRYING TO SEND A MESSAGE FROM THE CONTROL LOGIX PROCESSOR TO A PLC5 , DOES NOT SEEM TO WORK , IF ANYONE HAS SAMPLES OF THIS WOULD HELP OUT ALOT . tHANKYOU
  15. bulletin 1774

    okay there is a plc2 to plc5 conversion , then you export the .pc5 into work and change to SLC 500 adrresses, if you have a copy on a cassette 80 % of the time it can be imported into ai plc2 for a conversion. I only reason that it would not be able to import the ladder is if there is no End of the program put in the 1774 plc . Tell me how many rungs and could get you a price , I am out of Houston ,TX . this will import into any software that you want , BUT SOMETHING TO REMERBER IS IF YOU TRY TO INSTALL THIS INTO A PROCESSOR THAT WAS BUILT AFTER YOU SOFTWARE YOU SOFTWARE WILL NOT BE ABLE TO TALK TO IT . BARRY C