tid_chai

MrPLC Member
  • Content count

    33
  • Joined

  • Last visited

Community Reputation

0 Neutral

About tid_chai

  • Rank
    Sparky

Profile Information

  • Country Thailand
  1. I would like to know that if i have the old project " controlLogix 5563S+FlexBus-1794 " and then I ' d to add Um1500 ( servodrive ) . How can I do it ? And how can I write the program (่jog forward and revers with constant velocity) ? Please suggest the way to wiring and give me some examples for the program writting. I quite know too little about this. Please see the config as the file attached. Thank you in advance. rs-logix.bmp
  2. hi all i have micrologix 1200 i up load program from it but i not see comment in program i need see comment What can be done. Thank
  3. mitsubishi Q cpu Dive 7 segment 2 Digit

    Thank you
  4. Ge fanuce 90 30

    Hello All My plant is PLC Ge Fanuce 90 30 I want to back up the inside. But I do not know what the Program to upload. And I do not have cable for connecting to the PLC. I have to do Thank You
  5. Hello All i want Test Dive 7 segment 2 Digit By Output (Y 8 Bit 4 Bit/1Digit) What should I do. Please give examples. Thank You
  6. cmM2a And CP1E

    hello All i have CPM2A and CP1E 2 Unit i want Tranfer data from CPM2A Through rs232c to 2 CP1E I can do?
  7. Modbus in CJ2M CPU13

    Thank for Program but it Difficult to understand for me, please give a simple example of using PMCR to read data from node 1 of port 0 of the device at address 6001 (floating). Thank you.
  8. Modbus in CJ2M CPU13

    Hello there, quick question. i have cpu 13 and scu32 i want read data from other device but I have no experience in omron Please give examples Thank you very much
  9. analog output issue

    How to scaling functions in the software ?
  10. analog output issue

    Thank For All
  11. analog output issue

    Thank You But I insist Please see Image ScreenHunter_2.bmp
  12. analog output issue

    hello all i use 322-5HF00-0AB0 output low= 4.2ma High=20.2ma i want to make low= 4.0ma and high=20.0ma How to solve the problem? thank you
  13. GX IEC

    Hello I have One Question in GX IEC can Edit Online ? if It can how to Edit online Thank you
  14. S7 200 talk ASCII

    Thank you
  15. S7 200 talk ASCII

    if output analyzer is rs485 db9 port i can see pin of s7200 in manual and direct conect (not use PPI adeptor)?