MrPLC Member
  • Content count

  • Joined

  • Last visited

Community Reputation

7 Neutral

About Rodney

  • Rank
  • Birthday 07/24/51

Contact Methods

  • ICQ 0

Profile Information

  • Gender Male
  • Location Stoke on Trent UK
  • Country England

Recent Profile Visitors

5777 profile views
  1. omron CP1E-E30

    You would get a much better response if you posted in the Omron section.   Rodney
  2. MAC E-50 HMI

    It’s CAB 5 that you require.
  3. Simatic S7-200 Software?

    The software is Micro Win and the cable is a PPI cable Rodney
  4. Siemens S5 Backup Battery

    Then try your local Siemens distributor. They should be able to order it for you. Rodney
  5. Siemens S5 Backup Battery

    MDS Bateries online   Rodney  

    Hi Possibly the relay for that output the contacts have welded together.   Rodney
  7. Cx one software

    You have to buy it from Omron.
  8. Omron C200H CPU 01 problem

    As mentioned in my original post the DA001 was in fault and when I replaced the RM201 and the RT201 the DA001 went into run. Jay Do I toggle the restart bits you mentioned the address I am writing to in the program is 100 if that helps In the remote rack there the following l/O left to right input module address 60 output module address 61 output module address 62 empy slot DA001  
  9. Omron C200H CPU 01 problem

    Just been to site and checked again using CX  Programmmer and I could see a code number. The error code number is 0x00D0. Rodney  
  10. Omron C200H CPU 01 problem

    I have not seen an error code number only the description above. Any help in resolving this would be greatly appreciated. Rodney
  11. Omron C200H CPU 01 problem

    Thanks for your posts. Jay The RT201 has only the power indicator light. The RM201 has flashing fault light has does the CPU. Rodney
  12. Omron C200H CPU 01 problem

    Thanks  Jay but I have done a like for like replacement including the dip switch settings thanks Rodney      
  13. I was called to one of my customer this morning who has one of tha above PLC,s. The problem is that there is a remote rack and  it is not talking to the main rack and the PLC is not in run mode. There is also DA001 analog module in the remote rack which was in error. I exchanged both the RM201 and RT201 modules the comms is still not working but the analog module is now in run. Both the Rm201 and the R201 are in alarm. The alarm is described as a duplex bus or intelligent I/O unit. The cable between the two units buses out ok. any help on this would be appreciated    thanks  Rodney  
  14. How to remove and upload program in plc from pc?

    As Kaare_t said you must remove the power and the battery to reset the PLC. If you try to download your program without a reset the PLC will request the password. Rodney
  15. melsec A0j2H

    The software is G X Devloper and the cable is a SC09.   Rodney