mouni

if you have an expandable chassis, you must put the terminating resistor

salut essay de mettre le couvercle de la carte mémoire pour éliminer le voyant Ter What you like basic chassis?

tu as quoi comme châssis de base?

salut essay de mettre le couvercle de la carte mémoire pour éliminer le voyant Ter

can you send me an application demo (.ctz)

Hello, Excuse my bad english . I want to use Citect SCADA or Vijeo Citect to control and supervise a PLC (TSX Premium). So I have configured the communication (Ethernet TCP/IP), and an external device with the IP address that I configured with PL7 to my PLC, but I can't communicate with this device. Could you explain me what you did to communicate, and then read tags from PLC? Thanks.

is there someone who know the name of a mill that has used the Citect software

hello I want to know references Citect in the mill

hi i want to creat an accumulator and i know i have should to define it in citect.ini but i dont know how can i acces to citect.ini for the modification

thank

hello it is possible to immigrate an application with intouche to Citect?

it's good is resolved I failed to define the proper protocol (and not melsecf MELSEC) and after converting addresses to byte hexas

thank you but i m refer to JY997D16901 and the cable should be like this: cable.doc file attache cable.doc cable.doc

I think I have do everything I can, but the problem still persists I REFER TO DOCUMENT : JY997D16901 I realize I have the cable between plc and the computer DB25 DB9 3------------3 2------------2 20----------6 7-----------5 6-----------4 , I configured communication at the PLC (CITECT) REGISTRE D8120= H6883 (0110 1000 1000 0011) D8121 = H0 D8127 = K1 ACTIVE M8120 ON COMPUTER (CITECT) PARITY =ODD BIT STOP=1 DATA= 8 VITESSE = 9600 I THINK THAT IS ALL What is missing??????????

citect