Rhino1

Does anyone know how to increase the polling time between citect and the RTU. I am using a kingfisher frame. If an input changers on the input to the PLC it takes 7 seconds for the change to be made on my graphics page. Should something turn on, it takes around seven seconds for it to show that its on in my graphics page. Thanks.

Thanks. Yes I have worked it out. I had to set the variabled to point to the KingFisher frame. The varibles were previously set to use the emulated RTU. Thanks again.

I am hoping that someone will be able to assist me. I am new to SCADA and PLCs. I have created a "On" and "Off" button in SCADA, however I am not sure to control my Kingfisher PLC through SCADA. I have my Kingfisher frame connected via the com port and have set the board up in SCADA. I am not sure what I need to do to have SCADA talk to my Kingfisher frame. In my frame I have a number of Analogue input cards, digital output and digital input cards. If someone could assist it would be appreciated. Thankyou in advance.

I am hoping that someone will be able to assist me. I am new to SCAD and PLCs. I have created a "On" and "Off" button in SCADA, however I am not sure to control my Kingfisher PLC through SCADA. I have my Kingfisher frame connected via the com port and have set the board up in SCADA. I am not sure what I need to do to have SCADA talk to my Kingfisher frame. In my frame I have a number of Analogue input cards, digital output and digital input cards. If someone could assist it would be appreciated. Thankyou in advance.