jim5

Thanks for the reply Patrik. Yeah my program is the same. I have my modem set the same also. could it be something to do with flow control. Could it also be that i have left slightly to long of and memory area for the number and text. like setting it to k22 or the like... would this casuse such a problem...If you want ill send on the project to see if it works on your sytem. Thanks again Jim

Thanks very much for your reply. I have already created a program that does exactly what your saying. It takes my message and number from there original location and puts them in to a type of transmission zone for sending and then sends the to the modem in the correct order. But when i was tested it, it worked fine for the first time i sent a message but after the message was sent, i tryed it a second time but all that my mobile phone recieved was a blank screen. So some how the message is getting lost.. I messed around with the delays but to no avail. im just wonder if anyone knows a solution to this. Its probably something really simple im over looking. If you need more info ill post it asap Thanks Jim

thanks anyway jay

Thanks Jay so is it a case of when i send it to the service providers gateway, that they can read the email address straight from the text. could you give a small example. thanks AT+CMGS=PHONE NUMBER<CR>TEXT MESSAGE<ctrl-z>

Hi All, I have my plc sending text messages through my maestro gsm modem, when a given input is pulsed.( eventually it will be when an error is flaged). I use AT commands for the modem to use the "phone number" and "message to be sent", and they are stored as ansi II strings in the PLC. Now I'm just wondering how i would send an email. I know it will be practically the same way, but im guessing that there should be an extra AT command for the email address aswell as the phone number. I was in contact with my modile service provider and the gave me a phone number for their sms to email gateway. Hopefully someone can help me with this. Thanks very much.

Hi All, I have my mitsubishi FX 1N sending text messages through my maestro gsm modem, when a given input is pulsed.( eventually it will be when an error is flaged). I use AT commands for the modem to use the "phone number" and "message to be sent", and they are stored as ansi II strings in the PLC. Now I'm just wondering how i would send an email. I know it will be practically the same way, but im guessing that there should be an extra AT command for the email address aswell as the phone number. I was in contact with my modile service provider and the gave me a phone number for their sms to email gateway. Hopefully someone can help me with this. Thanks very much.

hello all I am trying to set up a Mit FX 1N and a gsm modem so that when an alarm is called it sends an sms (text message) or email. any help would be great thanks