Teropod

Thanks!

Hi all, i have problem and i think i don't hay any other information resource left to ask or check, whenever i try to use up or down edge in my program rung becomes red can CPM1 use ↑ or ↓ or i should use different methods? Thanks!

Hi everyone. I have Allen-Bradley Microogix 1000 and i would like to make scada for it, is there any manual for rs 232 communication, cable description (pinning)? Is it possible to to send him message and get return value of I/O, memory status? Thanks!

Output is set to sorce. CPU 224.

Hi i wanna turn on signal using other equipment while plc is connected will that damage plc?

Omg on these i can see my units are on 8ms. Thanks for help.

Its impossible to add new module since it should be software modification, i cant ask for new unit.

Ok i will try that thanks for replay.

I have signal that last 3ms and sometimes i have problem to not see it, cycle time is 2ms at least that is what programmers says how precise is it i don't know, in id261 description says that on response time is 20us ill assume that it is impossible to use that time as interrupt. In plc setup response time for rack 0 is 1ms. CPU is CJ1G-H 43. Is it possible for me to indicate changes even after 50us and create some interrupt looking program? I know that it could be signal folut but i wanna be 99% sure that i can track signal if he last at least 1ms so if he don't my hands are clean and i can be sure that isn't plc falut. Thanks!

Hi all sorry for these question but i cant find does plc store cycle time anywhere?

1. Question is there any data sheet with db9 pinnings from omron PT? 2.How high current can PT supply from 5V output if there is any? Thanks. Regards.

As much as i know they are auto increasing numbers very useful for indirect addressing. I was trying to find any documentation about how to use them, nothing really helped. Can you please direct me where to find any example or pdf? Thanks.

Thats really bad. :(

Hi all! I have question about updating system version on PT. Is it possible to update it without memory card? Can u please direct me where to look?

Thease project version(System version) is not supported by Cx-Designer installed. I have Cx- Designer 2 Do i need version 1 to open file?