Critt

MrPLC Member
  • Content count

    3
  • Joined

  • Last visited

Everything posted by Critt

  1. CJ1M problem

    I have a omron CJ1M Cpu 13 that I can't seem to get into run/monitot mode. I am using CX programmer version 7.01. I get the following error: "Failed to change the operating mode the operation mode may be still changing in the PLC"
  2. Q02HCPU CC-link problems

    Hello, I have a Q02HCPU with a QJ61BT11N Module in slot 9(0-9) which will communicate over cc-link cable to 5 remote I/O stations AJ65SBTB1-32D-U. I am not sure how to address these remote stations and the cc link master. Any help would be great.
  3. CJ1M problem

    No alarm light is on... so the dip switch for memory protection should be on or off? I connect using serial