I am new to Mitsubishi PLC's and I haven't worked with PLC in general in a few years, so I'm a little rusty... I am trying to setup an A series PLC with an A2SHCPU and a A1SJ71PB92D Profibus Card. I'm using GX Configurator-DP and GX IEC Developer 6.01. I can communicate with the CPU ok, and can download the project I have setup just fine. However, when I use GX Config to setup the ProfiBus network, GX Config doesn't see my PB92D card. Instead it sees an AD68DAV! Any ideas on what I could be doing wrong or how I can make this work? To setup the PB card in GX Devel, I first go to PLC Parameters/IO Assignment and set a "Special" card for slot 0, and assign it 32 IO points. Then I go to Module Configuration and PB92D from the pull down menu and browse for my dp file.
