About This File
Video screen shot of my desktop configuring a ML1100 to talk on ethernet.
Step one is to configure your project with an IP address then download your project with RS-232 driver using RSLINX using a CBL-PM02 cable.
Then connect a cross over cable if connected direct or use an ethernet hub between your ethernet card and the ethernet port on the ML1100.
configure your laptop in the same subnet and configure RSLINX with an ethernet driver. That should be all there is to it.
TIP: Use RSLINX 2.50 and above to talk to a ML1100...and RS Logix 7.0 or above to program online.
Enjoy...